914Driver MegaDork
12/29/17 10:17 a.m.

Woody generously offered to send me some center drills but they are actually end mills.  Unless I start a watch making business I will never use them; a Sucrets' box full of mills, the biggest of which is <1/4".  Some are tiny, like a human hair with a two flute tip.

If you can use them just pay the shipping.  I tried but can't post a picture but can send you a photo via email.





Jumper K Balls
Jumper K Balls PowerDork
12/29/17 10:32 a.m.

Shoot me a pic via PM and a shipping cost to 97402.


Woody MegaDork
12/29/17 9:13 p.m.

Since you can't use them Dan, I would be very happy if these end up in the hands of JKB.

Patrick MegaDork
12/29/17 9:23 p.m.

if  JKB can't use them I just recently gained access to a bridgeport that i don't know how to use, so i might be able to use them

914Driver MegaDork
12/30/17 8:40 a.m.

Cool, going to stop at a post office today to buy a bubble wrap envelope.  (I usually steal them from work....)

JKB, stand by the mail box.

12/30/17 9:53 p.m.

If the other folks decide against  them, I do. Sounds like they could be used with my Sherline. I'm not sure how useful they'd be on a Bridgeport. I'd anticipate by the description they'd have a 1/4 inch or smaller shank which might be a challenge on a full sized mill.

914Driver MegaDork
12/31/17 7:15 a.m.

I couldn't load a picture,  but there's one out there if you ask politely.



Cooter HalfDork
12/31/17 9:31 a.m.

Who mills baby ends??


I didn't even know this was a thing.

914Driver MegaDork
12/31/17 12:56 p.m.

Our Preferred Partners