Alan Cesar
Alan Cesar Dork
11/12/14 6:48 a.m.
feature_image

You've seen those Looney Tunes cartoons where a leak springs on a pipe, and Daffy or Wile E. or some other ill-fated, animated animal plugs it with his hand. Then a leak springs elsewhere, then elsewhere again and again and again until the character is drowning and our 8-year-old selves are rolling in laughter.

We're starting to feel the same way about our Miata's cooling system, except we're not laughing much this time. When we installed a new radiator cap that held proper pressure, one of our 20-year-old hoses burst a hole. So we ordered all new hoses from Mazda, flushed the system, and so overhauled the whole cooling system. Great!

Or so we thought.

Now we've discovered a couple of pinhole leaks in one of the cast metal pieces—the water pump inlet, to be precise. This piece is odd enough to only be available through Mazda, so we placed another order from Mazdaspeed Motorsports. They give discounts on OEM parts to all Mazda racers who sign up. This little guy isn't cheap though: Even with the discount, it's still a salty $76.

But we also needed to get back on the road in a jiffy. This is our daily driver, after all. We noticed the problem while we were visiting a friend who only had zip ties and duct tape at her disposal, so we fashioned a decent solution. It's not completely leak-free, but it's better, and we hope it'll hold until our replacement parts arrive at the end of the week.

Get rough race cars delivered to your mailbox: Subscribe now for tons of sports car content delivered throughout the year.

Read the rest of the story

HappyAndy
HappyAndy UltraDork
11/12/14 6:53 a.m.

JB weld.

Would that make a GRM trifecta of Macguver repairs? 1. Duct tape 2. Wire ties 3. JB weld

I used 2 of the 3 yesterday.

gearheadE30
gearheadE30 New Reader
11/12/14 7:17 a.m.

JB weld for sure. A lot of older dirt bikes use aluminum or magnesium water pump housings that get very pitted and eventually leak like that, and since you can't buy parts anymore, it's pretty standard fare to goop it up and then grind it back to the right shape. Bonus: the pitting provides a nice rough surface for the JB weld to adhere to.

RossD
RossD PowerDork
11/12/14 7:22 a.m.

I believe you should be able to restore the old part with electrolysis. You just need to use an aluminum sacrificial part.

Our Preferred Partners
KXQeJZwufBztv9at9pElHSKvgtz8X8HO3GMq35XnKtwXgMqmgt88hYDi9ZkckBBd