brakeharder New Reader
4/24/19 3:25 p.m.

Turn key track day car. Pre-season service just completed - fresh oil/filter, brake fluid bleed/refill, coolant flush/refill, front end alignment, nut and bolt check. All work completed by local BMW specialty shop (Wile Motorsport). Car is ready to go for 2019 season.

Pictures at this link:   Location: Ashland, MA   Price: $11,900. or B/O

Contact info:  call Kevin at 508-395-4190 (mobile - call or text)   email:

Car specs as follows:

Ford 5.0L V8 motor swap – 302 bumped up to 306
HP = 298, Torque = 300, measured at rear wheels, have dyno sheet
Motor built by Pat McMahon Racing, car/motor maintained by Wile Motorsport
Many Ford Racing Parts – GT40 aluminum heads, B303 cams, water pump
Canton extra volume, baffled oil pan
Summit Racing large capacity radiator
BMW UUC exhaust (with muffler) modified to mate with the Ford motor
Holley 650 race carburetor

Ford T5 transmission w/ MGM short shifter
Installed lower (0.85) 5th gear – makes it useable on the track
Hydraulic throw out bearing with remote reservoir
Custom drive shaft to mate the T5 trans to a BMW rear differential
3.15 LSD rear differential

ISC N1 Track Coilovers with race springs – new set-up, used for 2 track days
Treehouse Racing Lower Control Arm bushings
UUC front and rear sway bars and mounting hardware
Ground control adjustable camber rear arms
All subframe attachment points have welded in reinforcements from AKG

BMW M3 front calipers with brass guide bushings
Stock 325 rear calipers
PFC 08 brake pads
Steel brake lines
Sneed Speed front brake duct mounts

17x8.5" TR Motorsport with Hankook C51’s (on car, tires are old)
17x8.5 Kosei’s with 235-40-17 Nitto 01’s w/ half a track day.

Safe Racer Competition Cages 4-pt roll bar
Sparco EVO III driver’s seat on fixed VAC mounting plates
Recaro XL passenger seat on fixed VAC mounting plates
VAC drivers floor plate – custom fit
Massive products “dead” pedal 
Schroth 6 pt. racing harnesses on both seats w/ 2021 expiration date

MaxVelocity EVO II front splitter
Brooks Motorsport carbon fiber rear wing
Cowl induction hood for increased air intake/air cleaner clearance

Standard title
Weight – 2688 lbs. with ¾ of a tank of gas.

Robbie GRM+ Memberand UltimaDork
4/24/19 9:01 p.m.

very nice. my heart jumped a beat when I saw the ad since I had a 1993 325i that I 5.0 swapped and sold to someone who brought it to the east coast. 

This isn't my old car however. (looks a lot better!)

Our Preferred Partners