I was wondering if anyone of you guys could use these plates from a S4 FC that are cluttering up my shop.
The bellhousing end plate ate something and has a few gouges.. As best I can measure, they're around .002" ish, so you should be able to smooth 'em out if you can face it. It also has a bit of a gouge (pictured) near the port exit, which is fine since you'll be porting it anyway :)
The mid plate looks pretty good except for some staining from storage. It's got probably less than .001" of gooving.
I didn't get pictures of the pulley side yet, but it looks pretty good as well.
Gratis, you pick up in Stafford, CT, or I can meet you in the area.
Bellhousing:
Mid housing
You'll need to log in to post.
