I asked this a few days ago but didn't get the answer I was looking for. So here it goes again. When what was left of the project went though my hands for the motor I noticed the frame disconnects. I saw that they were very well made. Better than the ones I have found online. Now I need same to get my car going with said engine. I need them in 1". Did Danny make them. If I was still in the machine shop I would make my own. But now I don't have access to the machines it would take. Thanks for the help.
Steve Eckerich may have made them (he was a previous owner) and owns a machine shop in Asheville ( http://www.stampcometal.com/about.html )
I just want to know what you are talking about?
I just want to know what you are talking about?
They are in the pics of the frame being built. That was way before Steve had it. The off road guys call them tube clamps. It is just a way to bolt together a section of roll cage so you can remove it later. Chad
If you cannot find the OD of the bung you are looking for - buy the 1.55" ones I posted a link to in your other thread on the subject and have it turned down or drilled out as a female connector.
You'll need to log in to post.
