Mr_Asa said:
Most GMs of the 80s and 90s that aren't full size vehicles.
Something about the seating position in them torques my knee into a painful position and if I drive them for more than an hour my knee locks up. Happened with an El Camino, a Blazer, an S-10, and a few random ones that weren't in the family but were rentals or such.
Apparently I feel the need to vent about this El Camino.
This thread, and specifically this post has been sitting in the back of my head all day.
So, in 1985, my Uncle-In-Law, a Florida real-estate lawyer, went and bought an El Camino. This El Camino.
He kept this car for almost the rest of his life. This is somewhat amazing as he bought more cars than anyone I've ever met. Usually two a year, although some years he'd buy three or four. Well, fast forward to about a year or two before I graduated high school and went into the USAF; he had some idiot redneck pull the TBI from the 4.3L and slap on an Edelbrock intake, carb, and dual exhaust. It also had an HEI ignition on it, but I'm not sure if that was a factory setup or if it was something the redneck did, but whatever it was it had to be rigged up and had a crappy power wire running to it. More on that later.
It was done... poorly. The choke was held half-shut at all times by a zip tie. It idled at something like 1500+ RPMs (not sure what, as it didn't have a tach.) The exhaust leaked, it was badly put together in general. But he also had it repainted at that time and bought those bullet hole wheels, and to be fair it looked great.
About the time I joined the USAF, my Mom bought the car from my uncle-in-law (who she worked for as a paralegal.) Susie's rear end was pretty much shot, and I hadn't been able to re-install the 8" I pulled from a '68 Mustang, so Mom gave me the El Camino to drive. For about a year it was fine. At that point in time:
- The water pump died. The bolts were rusted in place, I couldn't remove them except with a rechargable dremel. I'd go work on dremeling the bolt out, battery would die, then I'd go back inside and recharge it. Luckily I was living on base and was less than 1/4 mile away from anything I needed to get to, work, chow hall, etc. I couldn't use the base auto hobby shop as I was on nights and they weren't open at all for anything but banker's hours. Andrews AFB sucked for shift workers. Likely all bases do, but with how top-heavy Andrews was, it was definitely worse.
- Couple months after that, the balancer went out. It went out in such a way that the ring slipped and wore a nice 1/4" deep semi-circle in the timing chain cover. I sourced a new balancer, timing chain cover, and timing chain. I tried to do the job in the parking lot again, tried to use the balancer bolt to install the balancer. Pulled the first threads out of the crank, buggered up the bolt. Panicked. Sourced a tap and die set from the shop, bought a new bolt (screwed up, only one I could find was at the speed shop just outside base, was a 12-point head, so I had to then buy a new socket,) bought a balancer installer which I still have and have used two more times! and finally got everything installed again.
- Chronic exhaust leak from crappy install of the exhaust. Went through multiple gasket sets.
- Remember the timing chain cover I installed? It constantly leaked oil. I pulled the pan multiple times, cleaned it all, redid it multiple times. Ultimately found out that somehow the pan itself was bent before I ever got it.
- Tried to go home on leave. Got from Andrews down about an hour into Virginia. Stopped for some reason and came out and tried to start the car and got nothing. Called a coworker that lived a couple doors down from me, he came down with some tools, poked at the car, got nowhere, so we went back to base. I burnt a day of leave and then next day went back down with my coworker's roommate (a Vehicle Mx troop) and we both poked at the car. He found the HEI ignition power wire had worked itself loose, crimped a new female spade end on it and I was on the road.
- Got out of the USAF, thankfully a year before I had bought my truck and I gave the stupid car back to my mom. Later, as I mentioned in my truck thread the lines on the truck rubbed through and I burned up a transmission. So I went and got the El Camino from Mom again. Shortly after I got it (4-6 months) the reverse gear in the transmission burned out. I became very adept at finding parking spots where I could pull all the way through.
- Had to replace the plugs. The back two on each side I had to break the ceramic in order to get them out. No clue how I got them reinstalled.
- Around the point where the reverse gear died, I realized I was getting particularly horrible gas mileage. Somehow, this car that had lived all of its life in Florida, except for about 2 years in DC, had a gas hose rust through. I fixed it in a parking lot.
A lot of the issues here are related to this being my second car that I really had issues with and was wrenching on on my own. However, the first five items? They happened within a year. Then I had the El Camino after getting out of the Air Force for about 14-16 months before getting my truck back, so those last issues cropped up in that short of a time.
This stupid berkeleying car let me down at every single turn, whenever it could. It never had a single issue with my uncle as the owner. Its giving its current owner, my mom's husband, fits as well. Maybe it was just mourning that my uncle sold it. Maybe my mom's husband is a horrible mechanic. Maybe the shop that did the swap for mom's husband was a bunch of idiots. No clue.
Mom let me know the other weekend that she's taking it to a shop in July in order to get it fixed, then she's going to give it to me.
Yay?