Location: Indianapolis
Price: $550 picked up in Indy, $600 if i have to drive somewhere more than 30 minutes to meet.
Shipping: No, but i will drive a couple hours with them stuffed in the back of my Jeep to make a deal
Condition: 9/10, only farted in a few times
Pics this weekend. They're not installed in anything.
Interested. My email is Armstrong390 at the yahoo place.
You have males!
If seat value drops according to the number of farts they've seen, I'd have to pay someone to take mine.
Idea: Buy mine, sell "mine" to a stranger, hand off your fart-filled ones.
Start the fart meter over.
Bump. Uploading pics now, will post in the morning.
Please buy now and help me recover from a really terrible wrenching day.
Pics.
Corbeau A4s for sale by concealer404, on Flickr
Passenger seat blemish:
Corbeau A4 blemish by concealer404, on Flickr
Driver's seat blemish:
Corbeau blemish 2 by concealer404, on Flickr
How bad was your day...and how different is a miata bracket from a mustang? Any pics of the bottom.
akylekoz wrote: How bad was your day...and how different is a miata bracket from a mustang? Any pics of the bottom.
It was really bad. 12 hours of wrenching on a car that in theory just needed a brake replacement (upgrading to sport brakes) and front hubs.
Ended with a rear wheel bearing being replaced, front hubs turning out to be good, front upper ball joint being bad, a bunch of brand new, but leaking brake parts, and a novel of an email sent to a miata parts vendor.
Miata bracket is probably quite a bit different from a Mustang, but i can grab a picture of the bottom in the next day or two for you. 
Are these the standard or shaved bottom. My helmet is at the roof for the first lap.
That, i have no idea. I'd assume standard, but don't know how to check. They did sit a little higher than stock Miata stuff with the supplied brackets. A little lower with the flat bracket/no slider setup i had for a short period.
If you're much over 5'9" you probably won't want to use the supplied sliders/brackets in a Miata unless you removed the rear mount bar from the floor of the Miata, then mounted directly to floor. Should buy you a good inch or so and maybe better front/rear angle.
You'll need to log in to post.
