I pulled the drawers from the back of my 99 4Runner before I sold it with plans to install them in the Bronco I was sure I'd buy. Then bought an F150 (whoops) so the drawers gotta go. They're built strong (and heavy) out of 3/4" plywood and 2x4s. Dimensions are 38" deep X 39.5" wide X 8.5" tall. They fit snugly between the wheel wells in a 3rd gen 4Runner and are close enough to the same height. Heavy duty slides for both drawers. One side is a little sticky but has been working for the last four years. They're covered in the finest indoor/outdoor carpet Lowes sells. The tan is a close match to the oak interior on the limited 4Runners. Edges are protected with aluminum angle. Gaps at the corners of the angle where I learned about planning for the kerf when you cut stuff.
