Any woodworkers here? What's this stuff worth?

This was in the lot of stuff I got from my stepdad. I'll never use it, so I'd like to sell it. Searching, I see prices all over the place and I don't know if it's worth something, or nothing.

Each pkg contains the 3 cutters needed for the head.

It's a shaper head and cutters for a radial arm saw or tablesaw.

People tend to be terrified of them after using them the first time. Usually because they didn't buy the shaper guard and fence set that goes with it.

They used to go for around $50 on eBay but I haven't looked in ages.

I have the single cutter model which is even more scary.

If you wanted to part with it, I might be interested. 

If I could make my own trim profiles at the theater instead of buying expensive millwork, I'd be down.

I have never used them, but if Shawn passes, I might be down.

In reply to Curtis73 (Forum Supporter) :

If you need it for the theatre, you should take it. You'll get more use than I will.

If either one of you is interested, $50 will get it done.

Let me know, I'll weigh it up and get a shipping quote.

In reply to ShawnG :

I could use it at the theater, but I also have a budget to buy what I need.  If you want them, go for it.

In reply to Peabody :

Sent you a message 

Curtis73 (Forum Supporter) said:

In reply to ShawnG :

I could use it at the theater, but I also have a budget to buy what I need.  If you want them, go for it.

Not to step on ShawnG, but if you need them for the theater, I'll pay the $50, or buy the duplicates if that's an option. 

In reply to Curtis73 (Forum Supporter) :

To poke in on the OPs post, I have a Craftsman shaper from the early '60s you might want. I'll PM ya soon. 

Few times I've tried using it, I don't have the knack of feeding it smooth enough to get even close to ok mounding!

metal doesn't split, if ya look at it wrong!!!

That would be cool! 

This forum rocks.